If print is successful, congrats but your work is not done yet
After IPA or Ethanol bath, check for holes on the side of ring. If holes are all closed off, you are overcuring. dial down the laser by 2 and try again
If many but not all holes of the ring are open after the ring is properly cleaned, you are very close. You can slightly reduce laser power by 1 or increase print speed to 100mm/s and see how it prints.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.