If the test print fails, check to see if there is anything sticking on the plate.
If there is nothing on the build plate and a thin layer in the vat, check your leveling
If there is partial print on the build plate and broken off into vat, then exposure is close. Recommend increasing laser power by 1 to 2
If there is nothing on the plate and nothing in the vat, please check your settings. Make sure laser power is correctly set and xy speed is at 4 under the settings. There should be something in the vat or plate if the system setting is correct
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.